Zombie Apocalypse Guy Finished!

In my last blog I posted some work in progress of an apocalyptic fellow I was working on. Today I finally finished him, so here's a photo:

I made the image "Greyscale" as I used 3 different coloured putties on him, plus the brass parts, so by making it grey in tone it makes it blend a lot better.

The figure will come in 4 parts because of casting reasons. The main figure is one part, but the hooks on his lower back, the hammer, and the chain are all separate parts which will need to be glued in place. Alternatively, the weapon doesn't need to be "glued" as it can be swivelled around to either be a hammer of an axe.

The chain will come separate which I will provide off a large reel of chains. This is because chains are often difficult to cast because of all the holes. So the buyer will be able to wrap the chain around the hammer however they think looks best. I like to think of it as customisation!

The hooks on the back may also cause casting difficulties, so for that reason again I have left them off (I used blue-tac in the photo haha). So again, it can either be left off, or for added detail it can be glued into place under his belt.

Finally, I will also be sending off the Grekwood sculpt along with the "not dalek" figure, who I shall name after the person it is based on, so Princess Bexi, to the casters. Hopefully these will not take too long to produce.

My full attention can now get back to those zombies!!